Multi rotor fan club

Code : Tout sélectionner

G. Programming via Transmitter  

Step 1: Enter program mode  Switch the transmitter on→Pull the throttle stick to the top position→Switch the ESC on, wait 2 seconds, you will hear two “beep” sounds, which denotes that Max. throttle has been confirmed→Hold the throttle stick at the top position, and then wait 2 seconds until you hear tune “♪ 1 2 3  ♪ 1 2 3”, that means you have entered the transmitter programming mode. 

Step 2: Select program parameters  Hold the throttle stick on top position, there’re 7 parameters can be set by using your transmitter. You would hear 7 different indicating sounds which correspond to 7 different parameters. Pull the throttle stick to the bottom position (full Off throttle) within 2 seconds after you hear the correspondent sound will brings you to the correspondent parameter setting status. The indicating sounds will repeat in turn as follow.  
1. “beep-”  (a short sound) which indicates the Brake Type   
2. “beep-beep-”  (two short sounds) which indicates the Timing Mode  
3. “beep-beep-beep-”  (three short sounds) which indicates the Start Force  
4. “beep-beep-beep-beep-”  (four short sounds)   ------------------- 
5. “beep-----”  (a long sound) which indicates the Control Frequency  
6. “beep-----beep-”  (a long sound and a short) which indicates the Low-voltage Protection 7. “beep-----beep-beep-”  (a long sound and two short) which indicates the Cutoff Mode  

Step 3: Select program values After entering parameter setting status, hold the throttle stick on the bottom position, you will be led to the repeat selection of that parameter setting status. Each sound likes 4 short sounds and one long sound (1 long sound=5short sounds), and by that analogy. After some sound, pull the throttle stick to the top position in 2 seconds, after you hear a tune “♪3 2 1 ♪3 2 1”, which means the correspondent value has been chosen and saved. Hold the stick on the top position, return to the second step and continue programming.   

Step 4: Exit program Pull the throttle stick to the bottom position within 2 seconds and hold on after saving parameters, until you hear a tune “beep----  beep- beep- beep-  ♪ 1 2 3”. Set the Min. Throttle at this moment and exit program and operate as normal.(beep----means Loading parameter. beep- beep- beep-means numbers of cells and ♪1 2 3 means ready. )